|author||Sam Ravnborg <email@example.com>||2005-07-11 21:13:56 -0700|
|committer||David S. Miller <firstname.lastname@example.org>||2005-07-11 21:13:56 -0700|
[NET]: move config options out to individual protocols
Move the protocol specific config options out to the specific protocols. With this change net/Kconfig now starts to become readable and serve as a good basis for further re-structuring. The menu structure is left almost intact, except that indention is fixed in most cases. Most visible are the INET changes where several "depends on INET" are replaced with a single ifdef INET / endif pair. Several new files were created to accomplish this change - they are small but serve the purpose that config options are now distributed out where they belongs. Signed-off-by: Sam Ravnborg <email@example.com> Signed-off-by: David S. Miller <firstname.lastname@example.org>
Diffstat (limited to 'net/wanrouter/Kconfig')
1 files changed, 29 insertions, 0 deletions
diff --git a/net/wanrouter/Kconfig b/net/wanrouter/Kconfig
new file mode 100644
@@ -0,0 +1,29 @@
+# Configuration for WAN router
+ tristate "WAN router"
+ depends on EXPERIMENTAL
+ Wide Area Networks (WANs), such as X.25, frame relay and leased
+ lines, are used to interconnect Local Area Networks (LANs) over vast
+ distances with data transfer rates significantly higher than those
+ achievable with commonly used asynchronous modem connections.
+ Usually, a quite expensive external device called a `WAN router' is
+ needed to connect to a WAN.
+ As an alternative, WAN routing can be built into the Linux kernel.
+ With relatively inexpensive WAN interface cards available on the
+ market, a perfectly usable router can be built for less than half
+ the price of an external router. If you have one of those cards and
+ wish to use your Linux box as a WAN router, say Y here and also to
+ the WAN driver for your card, below. You will then need the
+ wan-tools package which is available from <ftp://ftp.sangoma.com/>.
+ Read <file:Documentation/networking/wan-router.txt> for more
+ To compile WAN routing support as a module, choose M here: the
+ module will be called wanrouter.
+ If unsure, say N.